







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Driveway & Pavers: The Jacksonville Owner’s Guide
We keep Boral driveway pavers and compatible replacement pieces on hand at our Jacksonville shop, and a standard paver swap or driveway repair here typically runs $7,000 – $18,000 installed when full replacement is needed, while smaller repair sections run well below that. Most Jacksonville homeowners realize something’s wrong after a heavy summer rain: a paver has sunk into a soft spot, a corner has cracked off, or a section of the driveway now drains toward the foundation instead of toward the street. The good news is Boral pavers are modular, which means a failed section usually doesn’t require tearing out the whole driveway, just the affected run and the base beneath it.
We’re an independent Jacksonville contractor, not a Boral company, but we work with Boral products every week and know which pieces match which older runs. If you’re staring at a cracked paver and wondering whether it’s a simple swap or a base failure, call (904) 643-6243 and we’ll walk through what you’re seeing.
Which Boral Models This Applies To

Boral’s paver lines for residential driveways in Florida fall mainly into two camps: the Boral Clay Paver series (often found on older Avondale and Riverside Craftsman homes) and the Boral Concrete Paver lines, including the Boral Elite and Boral Stone series used widely in newer Jacksonville subdivisions like Bartram Park and Nocatee. The compatibility gotcha most homeowners miss: Boral changed several concrete paver dimensions by roughly 3mm around 2016, so a paver stamped with an older production code won’t always sit flush against a new one even if both say “60mm” on the paper spec. We check the actual measured thickness with a digital caliper on every match, because 3mm is exactly enough to create a trip edge on a driveway.
When we can still read a lot code or color stamp, we match OEM Boral pieces. When the run is too old or the stamp is worn off, we’ll show you the closest aftermarket equivalent, explain the color variance honestly, and let you decide before we order anything.
Styles & brands we work with







Signs Your Boral Driveway & Pavers Is Failing
- Sinking or cupped pavers near the garage apron. Jacksonville’s sandy-loam soil shifts with our wet-dry cycles, and a compacted base that’s been undermined by years of downspout runoff starts letting individual pavers drop by a quarter inch, then half an inch. This is a base failure, not a paver failure, and resetting the paver without fixing the base buys you maybe one rainy season.
- Cracked pavers along the tire tracks. The two strips where vehicle weight actually sits take an outsized beating, especially on driveways holding a full-size pickup or SUV. If cracks mirror the tire path, the base is still likely fine, and we can swap just the broken pieces.
- White mineral staining (efflorescence) that keeps returning. Florida humidity pushes moisture through concrete pavers constantly. Occasional efflorescence is cosmetic. Staining that reappears within weeks of cleaning often means water is being trapped underneath, which points to a drainage issue rather than a paver surface problem.
- Pavers rocking underfoot along the edges. Edge restraints in older Jacksonville installations were sometimes plastic spikes that heave out of the sand over time. Once the edge is loose, the whole field starts drifting outward during heavy rains.
- Sand washing out between joints after every storm. Polymeric sand breaks down faster in Florida’s UV and heavy afternoon downpours than manufacturers’ ideal-condition ratings suggest. If you’re seeing bare gaps after a year or two, the joint sand has likely reached the end of its useful life and needs full-depth replacement before weeds and ants move in.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Jacksonville, a full Boral driveway replacement runs $7,000 – $18,000 installed, with the spread driven by square footage, base condition, access for equipment, and whether we’re matching an existing Boral line or switching to a new one. Small repair sections, like resetting a sunken apron or swapping eight to ten cracked pavers, almost always come in under the cost of full replacement and are quoted per project after we see the site.
Every quote is written: parts and materials listed by name, labor staged, and no allowance line items that quietly stretch later. That’s the way Graham Stein writes every scope. The work itself carries our 365-Day Done Right Promise, which means if a paver shifts or a joint fails within a year, we come back and make it right. Drop cloths and shoe covers protect the path from the driveway into the house on every visit, and we send a photo of the clean-up before the crew pulls away.
| Driveway Service | Typical Range (Jacksonville) |
|---|---|
| Full Boral driveway replacement | $7,000 – $18,000 |
| Concrete driveway (new) | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway sealing | $250 – $700 |
| Paver repair / small section reset | Quoted per site |
DIY or Call Us?
A homeowner can safely inspect the joints, note where water pools after a storm, and check whether any pavers rock under a foot or hand. Those observations help us quote faster. What we don’t recommend doing yourself is pulling up a large section of driveway to “just look” at the base, because driveway pavers weigh upwards of 20 pounds each, and a hundred of them stacked wrong or set aside over a weekend is how backs get hurt and crews end up fixing both the driveway and the pile.
The real risk is subtle: you can reset a paver perfectly and still fail because the base underneath wasn’t compacted again. That’s the failure we see most often after a homeowner’s own repair. For a smaller paver patio or walkway, careful DIY is reasonable. For a driveway that carries two vehicles every day, call us at (904) 643-6243 and let us price the right fix, written down before any work starts.
FAQs

With a properly compacted base and maintained joint sand, Boral clay pavers can last 50+ years and Boral concrete pavers 25 – 35 years in Jacksonville’s sun, humidity, and heavy rain cycles. The paver itself rarely fails first; the base and edge restraints usually do. Call (904) 643-6243 if you’d like us to check whether your failure is paver or base, because that decision changes the scope and the price.
Yes, in most cases a sunken section, cracked pavers, or failed edge restraint can be repaired without tearing out the whole driveway. We reset the base under the affected area, swap in matching pavers, and re-sand the joints. Replacement only makes sense when the base has failed across most of the field or when matching pavers no longer exist and the visual mismatch would bother you more than the repair cost. Call (904) 643-6243 and we’ll give you a straight answer and a written price for both paths.
A small paver swap or edge repair is typically done in one day. Resetting a sunken section with base compaction usually takes one to two days. A full driveway replacement runs three to five days in Jacksonville weather, with the dumpster and material delivery scheduled on named days before we begin. We’ll give you the day count in writing when we quote the work.
We stock the most common Boral paver sizes and colors at our Jacksonville shop, and we can have less common matches from our supplier within a few days. Same-week installation is typical for stocked pieces. If you can send us a photo of the paver and any stamp on the underside, we’ll tell you before we schedule whether the piece is something we already carry or have to order.
If your Boral driveway is sinking, cracking, or washing out, call us at (904) 643-6243. Graham Stein or one of our crew will answer, ask what you’re seeing, and schedule a time to look. The estimate is free, it’s written, and it names the material, the day we start, and the price. Name the material, name the day, name the price, then there is nothing left to wonder about.
Written by Graham Stein, Owner, Elmstead Remodeling Jacksonville, serving Jacksonville and nearby areas.


